RE: Pyrocat HD

From: Loris Medici ^lt;[email protected]>
Date: 09/17/04-08:38:22 AM Z
Message-id: <000d01c49cc3$fbc89980$ce02500a@altinyildiz.boyner>

Sandy, Thank you very much! Will use the times you supplied as a
starting point. BTW, I use a Paterson tank requiring 290ml developer per
135 film. Is there any ill effect using this amnt. or should I use some
more (say... like 500ml or 1lt)? The dual purpose is fine especially for
my 4x5" pinhole negatives. I guess I will start to make Ziatypes soon
using pinhole negatives developed in Pyrocat HD.

Susan, according the table below, your times are a little bit on the
short side, not long... Thank you too.

Regards,
Loris.

> -----Original Message-----
> From: Sandy King [mailto:sanking@clemson.edu]
> Sent: Friday, September 17, 2004 4:48 PM
> To: alt-photo-process-l@sask.usask.ca
> Subject: Re: Pyrocat HD
>
>
> Loris,
>
> For scenes of normal contrast I recommend the following times, based
> on rotary processing in tubes with constant agitation at 72 degrees
> F, using the 1:1:100 dilution. For tray or tank increase development
> time by about 15-20%.
>
> FP4+ 7:30 (graded papers), 10:00 (VC papers)
> HP5+ 10 minutes (graded papers), 15:00 (VC papers)
>
> ...
>
> A negative developed in Pyrocat-HD that prints well on VC paper with
> a #2 filter will print well in kallitype or Pt./Pd. with a minimum of
> contrast control.
Received on Fri Sep 17 08:33:54 2004

This archive was generated by hypermail 2.1.8 : 10/01/04-09:17:55 AM Z CST