[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Juniper Config Commit causes Cisco Etherchannels to go into err-disable state
Steve let me clarify the config I am applying has nothing to do with an
LACP trunk or any of my existing LACP trunks. It is a completely different
configuration on a completely different interface, the only similarity is
that I am trying to configure a trunk interface on the Juniper side for
multiple vlans. There is no LACP configuration involved.
On Thu, Apr 5, 2018 at 2:26 PM, Naslund, Steve <SNaslund at medline.com> wrote:
> It really does not resolve anything it just allows a bad configuration to
> work. The guard is there so that if one side is configured as a channel
> and the other side is not, the channel gets shut down. Allowing it to
> remain up can cause a BPDU loop. Your spanning tree is trying to tell you
> something, you should listen or you could get really hard to isolate issues.
>
> Steven Naslund
> Chicago IL
>
> >-----Original Message-----
> >From: NANOG [mailto:nanog-bounces at nanog.org] On Behalf Of Joseph Jenkins
> >Sent: Thursday, April 05, 2018 4:16 PM
> >To: Robert Webb
> >Cc: nanog at nanog.org
> >Subject: Re: Juniper Config Commit causes Cisco Etherchannels to go into
> err-disable state
> >
> >No there isn't, but from what I am getting responses both onlist and off
> list is to just run this on the Cisco switches:
> >
> >no spanning-tree etherchannel guard misconfig
> >
> >and that should resolve the issue.
> >
> >Thanks Everyone.
>
>