[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
v6 & DSL / Cable modems [was: Private use of non-RFC1918 IP space (IPv6-MW)] (IPv6-MW)
On 5/02/2009, at 2:35 PM, Scott Howard wrote:
> What happens when a customer wants to run multiple networks is
> something I
> haven't seen answered yet - with NAT it's easy, but as I said, NAT is
> apparently evil...
You give them more than a /64.
RFC4291 says that it should be a /48, but people seem to be keen on /
56s now. /60s are even ok.
They key here is that is is divisible by 4, which leaves full hex
digits for the customer to twiddle. Somewhere (free.fr?) are doing /
61, which is a bit tough for people that aren't so technical.
Here in NZ, users typically purchase their own ADSL CPE, and that runs
PPPoATM over ADSL, and does IPv4 NAT and so on. What is also common,
is people buy a "wireless router" and plug it in to the back of their
ADSL router. They now have two layers of NAT between wireless hosts
and the Internet.
I looked at a packet trace of outgoing packets from an ISP - 17% of
outgoing packets were from behind double NAT like this (TTL was 62 or
126, as opposed to 63 or 127).
For this topology to work in IPv6, multiple levels of PD are required,
or users can no longer do this sort of plug-and-pray networking. Fun
Personally, I think we should have PD forwarding - ie. a router can
forward PD requests from routers behind it up to the ISP, and the ISP
can dish out another /64. It means there are more routes in that
particular router at the ISP, but it means you don't have to worry
about how much address space to give to each customer - if they need
more they ask for it automatically.