Re: Plate review: Printight model number KM 73

From: Ender100@aol.com
Date: 02/19/04-02:31:19 PM Z
Message-id: <194.24f3eb5e.2d667717@aol.com>

Just one correction—I think Peter will be surprised that his company has a
new name hehehehe

It's Copygraphics in Santa Fe : http://www.copygsf.com/

Mark Nelson

In a message dated 2/19/04 2:20:10 PM, jon@terabear.com writes:

> Using an inkjet printed step wedge (on Pictorico OHP) from a Dan Burkholder
> CD,
> I found this combination to work very well using plates Printight model
> number
> KM 73 available from Box Car press as "EcoEtch gravure plates for
> photogravure".
>
> I exposed in a frame vacuum (with light dusting of baby powder on the plate)
> using a bank of black light bulbs for the following times:
>
>     2 minutes: 80% density 300lpi continuous tone screen (from Alpha
> Graphics in
> Santa Fe - Thanks Peter!)
>     1 minute, 45 seconds:  step wedge transparency image (using all black
> ink)
>
> Full procedure here.  Feel free to send comments to me directly on the
> procedure:  http://www.lytescapes.com/procedures/intaglio.html
>
> Jon
>
Received on Thu Feb 19 14:31:56 2004

This archive was generated by hypermail 2.1.8 : 03/02/04-11:35:09 AM Z CST