gum development

From: [email protected]
Date: 12/06/04-09:14:26 AM Z
Message-id: <>

To take a break from all the RGB/CMY discussion I have a question to all
experienced gum printers (and others that just like to experiment). I
would like to develop my gums to a crisp white. I sieze my papers, so I
don't get any stain, but there is usually a very thin vail of color left.
I can rub it off with my finger, or a brush, but this is very crude. I
have been using a shower head to clear the highlights, but that tends to
leave a grainy look. I am wondering if others have tried other methods of
"forced" development, like maybe sawdust, or even sand in the tray. Any
chemical means to accomplish that?
Marek Matusz
Received on Mon Dec 6 09:23:06 2004

This archive was generated by hypermail 2.1.8 : 01/03/05-09:29:43 AM Z CST