[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Patch panel solutions for 4x10GE breakout

We generally run a MTP/MPO12 cable to a breakout cassette a few racks down,
and that's where we split out all of the LC pairs. It keeps the mess away
from the routers/traffic generators.

*Spencer Ryan* | Senior Systems Administrator | sryan at arbor.net
*Arbor Networks*
+1.734.794.5033 (d) | +1.734.846.2053 (m)

On Thu, May 5, 2016 at 10:28 AM, Phil Bedard <bedard.phil at gmail.com> wrote:

> So the newer equipment we are looking at uses QSFP+/MTP with 4x10GE
> breakouts to deliver 10G.  We are not wiring these up to things in the same
> rack, they will be going to patch panels and then elsewhere in a facility.
> It could potentially get messy with the panels we have today so we are
> looking at other solutions.  These are all SM LR connections using LC.
> There are a lot of SM MTP to LC options since that?s the way most panels
> are wired, but they typically have 6 duplex LC connectors per MTP and not 4
> which isn?t very efficient in this use case.  I?ve seen others just use an
> intermediate LC to LC panel and just wire the breakouts to those and then
> jumper the other side elsewhere.
> Anything else others have used?  The point of the solution is to keep the
> wiring mess in front of or near the device to a minimum.
> Thanks,
> Phil